Country Site

It looks like you are visiting the global website from .
Since we don't provide service to your country from this site, please visit your local Airzone website.

Support Center
I cannot associate a wireless thermostat
I cannot associate a wireless thermostat
If you cannot associate a wireless thermostat, run the following checks:

First check whether the system's main control board is operating properly. To do so, check the behavior of all its self-diagnostic LEDs and ensure they are as set out in the technical fact sheet (  Easyzone main controller - Flexa 3.0 - Product Data Sheet  ).

If the status of the main control board's LEDs is correct, check that the wireless association channel is open. This is indicated by LED D19 (red) being lit. If the LED is off, it is necessary to open the wireless module by pressing SW1 on the main control board or in the Wireless module parameter in the System advanced settings menu, zone parameters.

If the thermostat still cannot be associated, there may be a coverage problem. Bring the thermostat closer to the main control board and try to associate it again. If this time it is associated, it will be necessary relocate the thermostat which had no coverage.

If the thermostat cannot be associated, try associating another thermostat in that same area. If the association is possible this time, the problem seems to be located in the thermostat. If no thermostats can be associated to the main control board, the problem resides in the main control board.

As a final test, restart the entire system and reassociate it to discount hardware problems ( How do I reset the entire system?  ).

If the problems persist, get in touch with the Technical Support Department (  Open a new ticket  ).